Brand Name: Hengsen
Model Number: wkj-06
Place of Origin: China
Product introduction
This product is available for the temperature control system, such as the fan coil of control air-conditioner and heating system, electrical heater, heat pump and so on. The sensitivity of it is very high. And this product is very practical and easy to install.
Installation notice
·Temperature controller should be installed vertically on the indoor wall. And the height to the floor is about 1.5m for insuring the controller can get enough air.
·Make sure that there is no heat source and direct sunlight in the room of the controller.
·Firstly loose the screws of the lid to remove it. Secondly pass the wire through the long hole which is on the upper left side of the base plate. Thirdly connect and fasten the combined wire coil. Please do not dismantle the adjusting temperature button during the operation.
·Pass the wire through the square hole which is on the upper right side of the base plate. And connect and fasten the wire according to the wiring diagram.
·Fasten the base plate to the junction box with the self-contained complete screws.
·Put the switch and it’s plate to the bottom and install the lid. Make sure they are in the right place. Lastly fasten these screws.
·The self-contained complete wire box is built-in type. Its size is 86×86×32.
Specification and technical data.
Working range |
10-30℃ |
|
Control precision |
±0.8℃,when it is 20℃ |
|
Temp. Sensing parts |
Precision metal monopole change sheet boxes |
|
Switch rating current/voltage |
Thermostate |
220VAC±10%50/60Hz,micro-switches out put |
Fan switch |
6(2)A250VAC |
|
Lead connection |
Combined wire column/Be fit for maximum wire of 1.5㎜. |
|
Housing |
Material |
Tenacious fire engineering plastics |
Color |
Milky white |
|
Life |
Thermostat contact |
≥200000 times when it is 220V. |
Manual switch |
2000 times |
|
Working environment |
0-50℃ 10-90%RH No dew |
|
Storage temperature |
-40℃~ +70℃ |
|
Net weight |
About 200g |