heat tracing cable

water pipe thermo heat tracing cable  

The water pipe heating cable has the energy-saving temperature controller. When the temperature reaches the critical range, it will start the protection pipe automatically. The installation of the water pipe heating cable is convenient and you can install it by yourself. It is appropriate for the plastic and metal pipe. 

• The heating cable can prevent the freeze of the pipe and enable water to flow normally below 0°C
• The heating cable uses thermostat to save energy.
• The heating cable is suitable for the metal tube or the water filled plastic pipe.
• The installation of the heating cable is easy and you can install it by yourself in accordance with the installation and use instruction.  

Specification of water pipe thermo heat tracing cable : 

Note 
Voltage, Power, Cold Lead Plug, ect, can be designed according to customer's requirements. For example, 220/230V, 17w/m,16w/m or 20w/m,23w/m,etc.

Thermostat: imported from Japan, –ON:6±3°C ,  --OFF:13±3°C. Service Life: action for more than 100,000 ;

Package: plastic bag+small carton + big carton(16 or 10 small in one big carton)  

Attention!

Do not cut the heating cable!

Do not install where it can be damaged by game animals.-protect against biting.

Basically do not use tie wrap by installation 

Frost-proof water pipes with this heating cable:

Installation: 

1. first unwind the heating cable. The cable must never be connected to the power line when it is wound up.
2. if the cable is too inflexible because of low temperatures, unwind it and put it for some minutes into the plug.
3. afterwards you can pass the cable.
4. the area around the pipe where you want to connect it with the cable must be accessibly and non-attached.
5. the heating cable can not be passed behind walls
6. put the thermostat with the round black contact area tightly on the coolest point of the pipe and fix it with insulating tape.
7. finally put the whole cable on the pipe and fasten it every 30~60cm with insulating tape.
8. attention: the cable must be fastening straight on the pipe
9. now you can check if your cable works.
10. afterwards insulate the water pipe and the heating cable with mineral rock wool or foam. Attention: never use more than 13mm of this material to insulate.
11. in general the heating cable must be protected against mechanical damage or biting.
12. the heating cable can not be put into liquids.
13. finally plug the cable into a 230V main plug. 

Product show and package for frost protection heater cable :