Vented single screw PE PP plastic extruder for Making Geocell

Geocell Sheet Extruder

Specification

Equipment list:
1. SJ-1000X35:1 single-screw plastic extruder (non-vented) 1 set

2. Hydraulic quick screen changer 1 set

3. sheet discharge machine head 1set

4. Three-roll calender, 1 set
5. heat exchanger 1 set 6. Electrical control system 1 set
1) Main technical parameters of the unit:
2) SJ-150X35 single screw plastic extruder (exhaust type) 2.Screw diameter: 1000mm 3.Screw aspect ratio: 35:1-4800mm 4.Screw and barrel structure: special type for PE.PP material
6. Screw barrel structure: The screw barrel feeding section has special forced feeding grooves

7.Screw and barrel material: alloy steel 38CrMoAlA
8. The depth of the nitrided layer of the screw and barrel: 0.4-0.8mm, the brittleness is not more than 2 grades.
9. Reducer structure: Special type for vertical hard tooth surface, with oil pump forced lubrication system and forced cooling system.
10. Drive motor power: 132Kw 10.Transmission mode of drive motor and reducer: direct connectionSpeed ​​
11.regulation mode: frequency conversion speed regulation

12.Screw speed: 5-80r/min

13.Output: 380-520Kg/h

14.Vacuum pump: 3KW
15.Heating method: cast aluminum or ceramic electric heater

16.Heating power: 85Kw

17.Heating zone: 10 zones

18.Temperature control method: automatic temperature control.
19.Temperature control table selection: Huibang

20.Contactor selection: Chint

21.Hopper 1set

22.1 vacuum feeder 23.Feeding capacity: not less than 500Kg/h
 

Function: The hydraulic quick screen changer can effectively filter the impurities in the material, and can realize the removal of impurities without stopping the machine.
Screen changing method: slide type, hydraulic automatic screen changing
Material: 38CrMoAiA

Treatment method: Nitriding treatment
Nitride layer depth: 0.4-0.6mm

Nitriding hardness: greater than 900 C.PE.PP sheet mold
1.Sheet product width: 800-1000mm

2.Sheet product thickness 1.0-2.5mm

3.Head die width: 1000 adjustable

4.Machine head suitable for production thickness: 1.2-3.5mm adjustable
5.Machine head structure: The main channel is a hanger type, with a flow adjustment device inside

6.The die lip has a thickness and flow fine-tuning device.
7.Heating method: stainless steel electric heating rod heating

8.Heating zone: 12 zones

9.Head material: alloy steel for mold
1) Three-roll calender

I.Number of pressing rollers: 3 pcs

II.Calender roll diameter X effective length: 400X1200mm

III.Roller wall thickness: 40mm