YLL 1200MA Hebei coal travelling grate thermal oil furnace manufacturer

YLL organic heat transfer material heaters are the vertical type compositional liquid forced circulation boilers. With the compact heating surface, all the heaters consist of multilayer closely-arranged coils from inside, middle and outside and the ceiling coils. The internal surface of the inner coils and medium coils works as the radiant heating surface; and the outer surface of the medium coils and the outer coils works as the convection heating surface. The boiler comprises the upper body and the below combustor (chain grate stoker). When the fuel burns sufficiently in the combustor and most of energy is absorbed by the radiant heating surface, the high temperature flue gas enters into the convection heating surface to exchange heat. Then moves out of the boiler and enters into the waste heat boiler ( air pre-heater) to release heat further and then passes the dirt remover; and finally it is sent into funnel by induced draft fan and discharged into atmosphere.

Heating surface adopts the closely-arranged coils so as to lay out enough heating area. When the flue gas experiences many rounds of heat transfers in the ‘S-form” furnace chamber. The coefficient of heat transfer is very high.

The ceiling coil on the top of the radiant heating surface can protect the furnace top better and prevent it from being burned out.

The exhaust gas outlet is positioned right above the boiler, which can balance the heating surface and rationalize the structure.

With the rational medium procedure, the heat transfer oils enter into the boiler from the low position and flow out of it from the high position. In this way, the gas produced during the operation can be discharged out of boiler smoothly.

With the special design on the fire grate the furnace arch, the boiler can achieve independent regulation on air volume, which makes the sufficient and full combustion. It can use a wide range of coal as fuel.

It is very convenient to install the boiler because we only need to put the upper body and the below together.