Tube Temperature Sensor

CH-BA Immersion Temperature Sensor

Features    

·          Temperature measurement for water,oil,glycol.

·          Thermistor,PT or NI sensing elements to fit your system

·          Simple and secure installation

·          Wide range of temperature probes

Applications

·          Measure water temperature in return and supply water pipes.

·          Measure oil or glycol tempeature

Temperature Sensor

The sensor measures the temperature by use of a NTC, PT or NI sensing element. The sensing element is either a glass packed thermistor with a negative temperature coefficient or a platinum film sensor or a thin nickel layer on a ceramic substrate. Its resistance changes according to the temperature.

This sensor is constructed to high quality standards, borrowing materials and assembling techniques from the industrial sector. The probe material is stainless steel with a welded and ground tip. The probe is baked and then epoxy sealed to eliminate long term moisture problems.

Installation

Pipe probes should be installed directly on the water pipe

·          To install weld the M27x2 nut on to the water pipe apply sealant as required by pressure and media temperature and screw probe, by turning it clockwise into the welded on nut.

·          The pipe sensor is able to withstand pressures up to PN40. Welding will have to be done according to pressure requirements and following to local rules and regulations.

·          Connect the wires according to the wiring diagram to the measuring circuit in the cover:

o         The Thermistors require two conductors; normally 18ga unshielded twisted pair.

o         The PT100, PT1000 and NI1000 sensors come with each two terminal connectors in order to connect up to four conductors for compensating conductor resistance.

Technical Specification