10Ton 15HP Industrial Air Cooling Water Chiller

10Ton 15HP Industrial Air Cooling Water Chiller

Industrial water chillers are used for controlled cooling of products, mechanisms and factory machinery in a wide range of industries, including plastic injection and blow molding industry. The industrial chillers assist to improve the production efficiency and minimize the rejection ratio of finished products. A chiller will use either a vapor compression or absorption cycle to cool. 

Chillers can be either air-cooled or water-cooled.

Air-cooled chiller requires less maintenance than water-cooled unit and it dispenses with the need for cooling towers. However, the air-cooled chiller generally consumes approximately 10% more power than a water-cooled unit. It transfers the heat absorbed to surrounding air directly.

Water-cooled chiller absorbs heat from process water and transfers it to a separate water source such as a cooling tower, river or pond. A cooling tower is a must if there is no direct discharge source like river or pond. The water could be reused after special treatment to remove the dusts and impurities.

There are 10kw-200kw cooling capacity for you choosing. Please kindly contact us for you detail request.
Features:
1.cooling temperature range 5-35 centigrade temperature.
2. High-capacity tube-in-shell evaporator with very good heat exchange performance especially under high ambient temperature condition. The heat exchange power is: 15KW
3.Tube-fin double condensers with excellent heat transfer and rapid cooling. The efficiency of condensers is 17.5KW
4. Stainless steel warm-keeping water tank.
5. Overload protection for compressor, pump and blower.
6. Warm-keeping design for all piping to avoid partial convection.
7. Independent temperature controller, anti-freeze protection.
8. Phase sequence protection for control circuit, refrigeration loop controlled by high and low pressure switch.
9. R22 refrigerant to be used for efficient cooling.